46
Layers Name Box
The Layer Name box displays the current Layer Name. The Layer Name defaults to the name
of the Keymap used by that Layer. To change the name of the current Layer, simply click
inside the Layer Name Box and type a new name (the cursor can be placed anywhere in the
name). Up to 16 characters can be specified. When you are finished, click the OK button to
accept and enter the new name.
In order to save the name change in a Layer you must write the Program to the PC3
using the WRITE button.
MUTE and SOLO Buttons
The red and yellow buttons beneath the Layer Name box allow you to mute and solo the
current Layer. These buttons toggle the respective function ON and OFF. A lit button indicates
an ON status:
To Next Page
Loading...
