Checklist
69
Checkl is t
Tractor
Check
•
Is the inner wheel distance 110-160 cm?
•
Is the pressure in the left and right tyres equal?
•
Are both lower link arms at the same height?
Mounting
Check
•
Are the hoses trapped or stretched?
•
Is the top linkage inclining slightly from the plough towards the trac-
tor?
•
Is the linkage geometry point of draft slightly behind the tractor
front axle?
•
Is there sufficient clearance from the tractor?
•
Is there sufficient rear clearance for the depth wheel?
Driving on the road
The following must be carried out:
Adjust plough at narrowest working width
Stabilise the lower draw arms
Close the valve on the working width cylinder [+]
Activate the transport lock (when transporting in the half-turned po-
sition)
Use the transport wheel
Disconnect the top linkage (when using the transport wheel)
Stabilise the rotating drag axle [+]
Ploughing
The following must be carried out:
Destabilise the lower draw arms
Check
•
Is the first furrow width the same as the other furrows?
•
Is the first furrow width the same as the left and right furrow widths?
•
Is the plough frame parallel to the ground?
•
Are the beams square to the ground?
•
Disc coulters, Skimmers, Trashboard equal on all bodies?
To Next Page