Setting the Skew
To set your LNB to the proper skew, follow the steps below.
1. Turn off the power to the antenna.
2. Remove the radome and set it aside in a safe place.
3. Loosen the two wing screws securing the LNB
within the choke feed, as shown in Figure 5.
4. Refer to the skew labels on the end of the LNB and
on the LNB choke feed (shown in Figure 6) and
adjust the LNB as necessary to match as closely as
possible the correct skew.
5. Retighten the wing screws.
6. Reinstall the radome.
5
54-0150 Addendum to Rev. G
Figure 5
LNB Skew Adjustment
Figure 6
Skew Labels
Skews for PAS 9 are all positive (+)
angles. Do not set the skew to a
negative number.
Positive
Skews
To Next Page
Loading...
Need help?
General
