Kwikset SMARTCODE 916 - Install the exterior touchscreen; Exterior Touchscreen Diameter; Exterior Assembly and Mounting Plate Installation; Install the interior assembly

If the touchscreen indicates a failure, attempt this procedure again.
If the door handing process is still unsuccessful after a second
attempt, perform the “Manual Door Handing” procedure on page 4.
21/8"
54 mm
11/2"
38 mm
actual
size
T
2 / 4
U
(2x)
bottom
hole
What is the diameter of the hole in the door?
Remove battery cover and battery pack from interior assembly. Install interior assembly onto mounting plate.
Locate screws for step 3C and keep them within reach.
Install exterior touchscreen and mounting plate.
A
A B
B
C
Diameter is 21/8"
(54 mm)
Diameter is 11/2"
(38 mm)
or
“D” is required for installation.
Install “D” on “F”.
“D” is not needed for
installation. Discard “D”.
Cable goes
underneath latch.
Support exterior
assembly during
mounting plate
installation.
Route cable through
center hole, then push
cable into bottom hole.
Insert key and
test latch. If latch
does not extend or
retract smoothly,
adjust screws (T).
Remove key when
inished and make
sure the latch bolt
is fully extended.
Keep parallel to
edge of door.
Tighten
screws evenly.
a
a
c
c
b
b
d
d
Make sure turnpiece is in
the vertical position.
Make sure
turnpiece shaft is
rotated as shown.
Do not install
batteries until step 6.
K
W
This step will teach your lock the orientation of your door and is crucial to lock operation.
Install 4 AA batteries in battery pack. Make sure the door is open, and
insert the battery pack.
After a few seconds, the latch bolt will retract and extend on
its own to learn the orientation of the door. This is called the
door handing process, and it is crucial to lock operation.
A B C
D
Ensure correct polarity.
For best results, use
new, non-rechargeable
Alkaline batteries only.
Once the door handing process
is complete, the touchscreen
will indicate success or failure:
Success:
lashing checkmark
symbol and single
column of digits
Failure:
lashing
“X” pattern
Ensure tight cable
connection.
Lay excess cable lat inside the
bottom of the interior housing.
align
L
a
c
b
d
U
actual
size
K
D
D
F
F
G
T
T (2x)
T
E
M
L
L
L
K
4
Install the exterior touchscreen
5
Install the interior assembly
6
Install the batteries and perform the door handing process