5. FUEL SYSTEM
5-16
REED VALVE (50cc-2T)
REMOVAL
Remove the oil pimp control cable plate.
(See page 4-17)
Remove carburetor. (See page 5-11)
Remove the three intake manifold bolts and
gasket.
Remove the reed valve and gasket.
INSPECTION
Check the reed valve for damaged or weak
reeds.
Check the reed valve seat for cracks, damage
or clearance between the seat and reed.
Replace the valve if necessary.
INSTALLATION
Install the reed valve in the reverse order of
removal.
Do not disassemble or bend the ree
stopper. To do so can cause loss of
engine power and engine damage. If any
of the stopper, reed or valve seat is
faulty, replace them as unit.
＊
Install a new gasket with the gasket
indentation aligned with the reed valve.
After installation, check for intake air
leaks.
＊
Reeds
Reed Valve Sea
To Next Page
Loading...
Need help?
General
