12. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
12-13
STEERING SYSTEM
HANDLEBAR REMOVAL
Remove the following parts:
Handlebar and Front fender.
Refer to the “FRAME COVER” section in
the CHAPTER 2
INSPECTION
Inspect the handlebar.
Replace if cracks, bends or damage.
INSTALLATION
Install handlebar and handlebar holder, then
tighten the four bolts.
Torque: 14 N-m (1.4 kgf-m, 10 lbf-ft)
Refer to the “BRAKE FREE PLAY”
section in the CHAPTER 3 to adjust front
brake.
Brake cable free play:
10～20 mm (0.4～0.8 in)
• Align the mark on the handlebar with
the lower handlebar holder surface.
• Be sure the upper handlebar holder
mark face to front.
• Fist tighten the bolts on the front side
of the handlebar holder, and then
tighten the bolts on the rear side.
＊
Mark
To Next Page
Loading...
