12. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
12-16
Apply the grease onto the rubber collar and
then install the rubber collar.
Install the steering bracket and tighten the
two bolts.
Torque: 22 N-m (2.2 kgf-m, 16 lbf-ft)
Install the tie rods and tighten the nuts.
Torque: 35 N-m (3.5 kgf-m, 25 lbf-ft)
Install the cotter pin and band ends of cotter
pin.
Apply the grease onto the end of the throttle
cable and end of the brake cable.
Always use a new cotter pin.
*