13. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
13-21
INSPECTION
Inspect the caliper cylinder wall and piston
surface for scratch, corrosion or other
damages.
If any abnormal condition is noted, replace
the caliper.
ASSEMBLY
Clean all removed parts.
Apply silicon grease to the pistons and oil
seals. Lubricate the brake caliper cylinder
inside wall with brake fluid.
Install the oil seals and then install the brake
caliper pistons with the grooved side facing
out.
Wipe off excessive brake fluid with a clean
shop towel. Apply silicon grease to the
brake caliper holder pin and caliper inside.
Install the brake caliper holder.
Install the piston with its outer en
To Next Page
Loading...
Need help?
General
