KYMCO MXU 50 REVERSE - Page 39

1. GENERAL INFORMATION
1-36
ATV 50
CLUTCH, DRIVE AND DRIVEN PULLEYS
c Worn or slipping drive belt
d Broken ramp plate
e Broken driven face spring
f Separated clutch lining
g Damaged driven pulley shaft splines
h Damaged final gear
i Seized final gear
c Broken shoe spring
d Clutch outer and clutch weight stuck
eSeized pivot
c Worn or slipping drive belt
d Worn weight rollers
e Seized drive pulley bearings
f Weak driven face spring
g Worn or seized driven pulley bearings
c Worn or slipping drive belt
d Worn weight rollers
e Worn or seized driven pulley bearings
c Oil or grease fouled drive belt
d Worn drive belt
e Weak driven face spring
f Worn or seized driven pulley bearings
STEERING HANDLEBAR DOES NOT TRACK STRAIGHT
(Front and rear tire pressures are normal)
c Steering stem nut too tight
d Broken steering steel balls
c Excessive wheel bearing play
d Bent rim
e Loose axle nut
c Misaligned front and rear wheels
d Bent front fork
Engine starts but motor-
cycle does not move
Engine lacks power a
t
start of a grade (poor
slope performance)
Steering is heavy
Front or rear wheel is
wobblin
g
Symptom
Symptom
Probable Cause
Probable Cause
Engine lacks power a
t
high speed
There is abnormal noise
or smell while running
Motorcycle creeps o
r
engine starts but soon
stops or seems to rush
out (Rear wheel rotates
when engine idles)
Steering handlebar pulls
to one side