3-38
MD1326
4. Remove the shift fork shaft and the outer shift
fork.
MD1327
5. Remove snap ring and gear from the output side of
the gear cluster. Remove the gear cluster and the
inner shift fork together. Account for snap ring,
gear, and washer.
MD1328
6. Noting the position of the slot on the end, remove
the shift cam assembly. Account for inner and
outer washers.
KC325
7. Remove the counterbalance gear. Account for the
key.
8. Remove the counterbalance shaft.
MD1024
9. Using Crankcase Separator/Crankshaft Remover,
remove the crankshaft.
MD1330
! CAUTION
Do not remove the remaining output shaft assembly
unless absolutely necessary. If the shaft is removed,
the shaft nut must be replaced with a new one and
the shaft must be re-shimmed.
To Next Page
Loading...
