4-8
KC258A
KC266
3. Install the carburetor onto the engine making sure
the alignment lug on the carburetor is between the
two tabs on the air intake pipe; then tighten the
clamp securely.
KC245A
KC256A
4. Connect the intake air housing and tighten all
clamps and mounting hardware securely.
KC257
5. Install the gas tank (see Gas Tank in this section).
Throttle Cable Free-Play
To adjust throttle cable free-play, see Section 2.
Engine RPM (Idle)
To adjust the idle RPM, see Section 2.
Gas Tank
REMOVING
1. Turn the gas tank valve to the OFF position; then
remove the seat and side panels.
2. Remove the cap screws (A) securing the rear of
the front body to the frame; then remove two rein-
stallable rivets (B) securing the gas tank cover to
the body.
! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
To Next Page
Loading...
