Get Started 3
 Plug the other end of the USB cable into the charger, and then plug the charger into
an electrical outlet.
Note: Your phone’s battery should have enough charge for the phone to turn on and find a
signal, run the setup application, set up voicemail, and make a call. You should fully charge the
battery as soon as possible.
3. Press and hold the Power button to turn the phone on.
 If your phone is activated, it will turn on, search for service, and begin the setup
process.
 If your phone is not yet activated, see Activate Your Phone or more information.
Charge Your Phone Wirelessly
Your phone supports the PMA standard via a wireless charging accessory (sold separately).
Follow the steps below to charge your phone wirelessly.
Important: Use only wireless chargers that are approved by the manufacturer of your phone.
1. Place your phone on the wireless charger, ensuring that the charging area of your phone
touches the charging area of your wireless charger.
2. When you see "Wireless charging" on the status bar, slide down the status bar to display
the Notifications panel, and then touch Wireless charging.
3. Your phone will display a wireless charging screen instructing you to make sure the
screen logo is directly above the charging device center emblem.
To Next Page
Loading...
Need help?
General
