Kyocera copier

Section 5 COPY FUNCTIONS
5-7
4 Press the Number of Copies / Zoom(+) or the Number of
Copies / Zoom(-) key to select the desired borderline.
The displayed code numbers refer to the available
borderline types as explained in the following table.
5 Press the Recall%/Enter key.
The displayed numbers will flash and the copier will return
to a copy-ready state.
Selecting the order of 4-in-1 layout
Perform the following procedure if you want to select the order in
which the images will appear within the copy page in the 4-in-1
mode.
1 Press down on the 2in1/4in1 key for at least 3 seconds.
2 Press the Number of Copies / Zoom(+) or the Number of
Copies / Zoom(-) key until “F17” (Default item: 4-in-1
Layout Order) is shown.
3 Press the Recall%/Enter key.
Code number Borderline types
1- None
2- Solid line
3- Dotted line
1-:
12
34
3-:
12
34
2-:
13
24
4-:
13
24