3-8
Common Operations > Loading Originals
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
Originals Supported by the Document Processor
Originals Not Supported by the Document Processor
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam).
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before
loading. Failure to do so may cause the originals to jam).
How to Load Originals
1
Adjust the original table size.
?
Weight 45 to 160 g/m² (duplex: 50 to 120 g/m²)
Size Maximum A3 to Minimum A5-R
Maximum Ledger to Minimum Statement-R
Capacity Plain paper (80 g/m²), Colored paper, Recycled paper, High quality paper:
50 sheets (Mixed size originals: 30 sheets)
Thick paper (157 g/m²): 25 sheets
Thick paper (120 g/m²): 33 sheets
Art paper: 1 sheet
• Do not make an impact on the document processor top cover, such as aligning the originals on the top
cover. It may cause an error in the document processor.
• Before loading originals, be sure that there are no originals left on the original eject table. Originals left on
the original eject table may cause the new originals to jam.
To Next Page
Loading...
Need help?
General
