Kyocera ECOSYS M6530cdn

8-32
Setup and Registration (System Menu) > System Menu
SNMPv3 -
Protocol Setting Select whether to communicate using SNMPv3.
*1
Value: Off, On
Available Network
(Wi-Fi Direct)
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [Protocol Setting] is set to [On].
Available Network (Wi-Fi)
*2
Available Network
(Wired Network)
HTTP -
Protocol Setting Select whether to communicate using HTTP.
*1
Value: Off, On
Available Network
(Wi-Fi Direct)
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [Protocol Setting] is set to [On].
Available Network (Wi-Fi)
*2
Available Network
(Wired Network)
HTTPS -
Protocol Setting Select whether to communicate using HTTPS.
*1, *3
Value: Off, On
Available Network
(Wi-Fi Direct)
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [Protocol Setting] is set to [On].
Available Network (Wi-Fi)
*2
Available Network
(Wired Network)
IPP -
Protocol Setting Selects whether to receive documents using IPP. To use the IPP protocol, select [Not Secure
(IPP&IPPS)] on IPP Security under Security Settings from the Command Center RX.
*1
Value: Off, On
Port Number Set the IPP default Port Number. The default port number is 631.
Value: 1-32767
NOTE
This function is displayed when [Protocol Setting] is set to [On].
Available Network
(Wi-Fi Direct)
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [Protocol Setting] is set to [On].
Available Network (Wi-Fi)
*2
Available Network
(Wired Network)
Item Description