Kyocera ECOSYS MA4500fx - Printer

8-44
Setup and Registration (System Menu) > System Menu
Printer
[System Menu/Counter] key > [ ] [ ] key > [Printer] > [OK] key
Printing from computers, settings are generally made on the application software screen. However, the
following settings are available for configuring the defaults to customize the machine.
Item Description
Emulation Set. Select the emulation for operating this machine by commands oriented to other types of
printers.
Value: Line Printer, IBM Proprinter, EPSON LQ-850, PCL6, KPDL, KPDL (Auto)
NOTE
When you have selected [KPDL] or [KPDL (Auto)], set "KPDL Error Rpt", too.
Alt. Emulation When you have selected [ KPDL (Auto) ] as emulation mode, you can switch between KPDL
and another emulation mode (alternative emulation) automatically according to the data
to print.
Value: Line Printer, IBM Proprinter, EPSON LQ-850, PCL6
KPDL Error Rpt When an error has occurred during printing in KPDL emulation mode, set whether or not
the error report is output.
Value: Off, On
EcoPrint EcoPrint conserves toner when printing. This is recommended for test copies where
faded printing is not a problem.
Value: Off, On
Override A4/LTR Select whether to treat A4 size and Letter, which are similar in size, as the same size when
printing.
Value
Off: A4 and Letter are not regarded as the same in size.
On: A4 and Letter are regarded as the same in size. The machine will use whichever
size is in the paper source.
Duplex Select binding orientation for duplex mode.
Value: Off, Bind Long Edge, Bind Short Edge
Copies Set the default number of copies, from 1 to 999.
Value: 1 to 999 copies
Orientation Set the default orientation, [Portrait] or [Landscape].
Value: Portrait, Landscape
Wide A4 Turn this to on to increase the maximum number of characters that can be printed in a
line for an A4 page (78 characters at 10 pitch) and Letter size page (80 characters at 10
pitch). This setting is only effective in PCL6 emulation.
Value: Off, On
FormFeed TimeOut Receiving print data from the computer, the machine may sometimes wait if there is no
information signaling that the last page does not have any more data to be printed.
When the preset timeout passes, the machine automatically prints paper. The options are
between 5 and 495 seconds.
Value: 5 to 495 seconds (in 5 second increments)
LF Action Set the line feed action when the machine receives the line feed code (character code
0AH).
Value: LF Only, LF and CR, Ignore LF
CR Action Set the character return action when the machine receives the character return code
(character code 0DH).
Value: CR Only, LF and CR, Ignore CR