Kyocera ECOSYS P5021cdn - Page 168

7-23
User Authentication and Accounting (User Login, Job Accounting) > Administrator settings
2
Configure the settings.
The setting items are as follows.
Item Descriptions
Change ID You can use this to set the administrator ID. The factory default settings
for the administrator ID is set as shown below.
Select the [▲] or [▼] key to increase or decrease, respectively, the value
at the blinking cursor. Enter the specified ID. Select the [◄] and [►] key
to move the cursor right and left. Enter an ID consisting of between 1 and
16 numbers.
Change Password You can use this to set the administrator password. The factory default
settings for the administrator password is set as shown below.
Select the [▲] or [▼] key to increase or decrease, respectively, the value
at the blinking cursor. Enter the password to be changed. Select the [◄]
and [►] key to move the cursor right and left. Enter a password
consisting of between 0 and 16 numbers.
NOTE
The administrator password is not displayed.
Model Name Administrator ID
ECOSYS P5021cdn/ECOSYS P5021cdw 2100
ECOSYS P5026cdn/ECOSYS P5026cdw 2600
Model Name Administrator
Password
ECOSYS P5021cdn/ECOSYS P5021cdw 2100
ECOSYS P5026cdn/ECOSYS P5026cdw 2600