19
Important note on the interface connectors
Be sure to turn off printer power before connecting or disconnecting an interface cable to the printer.
For protection against static discharge which may be applied to the printer's internal electronics
through the interface connector(s), keep any interface connector which is not in use capped using
the protective cap supplied.
Note:
Use shielded interface cable.
Safety information
Laser notice
This printer is certified as Class I laser product conforming to the requirements of IEC 60825.
DANGER: INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO BEAM.
■ Caution labels
Ozone concentration
The printers generate ozone gas (O
3
) which may concentrate in the place of installation and cause
an unpleasant smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recommend
you not to install the printer in a confined area where ventilation is blocked.
-
Label inside the rear
Label inside the printer (Laser radiation warning)
Label on the printer's rear panel
To Next Page
Loading...
