NETWORK SCANNER SETUP GUIDE 1
1 Preparations
Connecting the Cables
The machine can be connected to a network or directly to a PC.
Connecting the Network Cable
When connecting the machine to the network, use the appropriate network cable
(10BASE-T or 100BASE-TX).
1
Ensure the machine is off, and remove the
power cord from the outlet.
2
Connect the network cable to the network
interface connector at the rear of the
machine.
3
Connect the other end of the network cable to your network device.
4
Change the appropriate network settings on the operation panel - refer to Network
Settings on page 5.
Connecting the Parallel or USB Cable
Before connecting via the USB interface, install the necessary drivers from the
included Product Library CD.
To connect the machine directly to your PC, use either a parallel cable or USB cable.
1
Turn the machine off, remove the power cord from the outlet and turn the PC off.
Get other manuals https://www.bkmanuals.com
To Next Page
Loading...
