Kyocera FS-1700 - Table of Contents

Table of Contents
xvii
Table of Contents
Chapter 1 Installing the Printer...........................................1—1
1.1. Positioning the Printer ...........................................................1—1
Clearance
............................................................................................................ 1—1
Places to Avoid
.................................................................................................... 1—1
Basic requirements
.............................................................................................. 1—2
Power Supply
...................................................................................................... 1—3
1.2. Unpacking and Inspection .....................................................1—3
List of shipped components
................................................................................ 1—4
1.3. Names of Parts .......................................................................1—5
Front View
.......................................................................................................... 1—5
Interior View
....................................................................................................... 1—6
Rear View
............................................................................................................ 1—6
1.4. Setting Up and Interfacing.....................................................1—7
1—Open the Top Cover
....................................................................................... 1—8
2—Install the Toner Container
............................................................................. 1—8
3—Close the Top Cover
....................................................................................... 1—9
4—Install the Waste Toner Bottle
........................................................................ 1—9
5—Add Paper
................................................................................................... 1—11
6—Open the Paper Stopper on the Face-down Output Tray
............................... 1—12
7—Install the Face-up Output Tray (if required)
................................................. 1—12
8—Connect the Printer to the Computer
........................................................... 1—13
9—Attach the Power Cord
................................................................................ 1—13
10—Print a Status Page
..................................................................................... 1—14
11—Test the Interface with the Computer
......................................................... 1—14
12—Set the Emulation Mode
............................................................................ 1—14
13—Install the Printer Driver
.............................................................................. 1—15
1.5. Multi-Purpose Tray Feeding .................................................1—17
Selecting the Multi-Purpose Tray
........................................................................ 1—17
1.6. Memory Card........................................................................1—21
Handling Memory Cards
.................................................................................... 1—22
1.7. Memory Expansion Installation ...........................................1—23
Removing the Main Circuit Board
...................................................................... 1—23
SIMM to be used
............................................................................................... 1—25
Installing and Removing SIMMs
......................................................................... 1—25
Testing the Expansion Memory
.......................................................................... 1—26