Kyocera FS-2000D - Page 100

2F8/2F9/2GA
1-5-28
(3) Detaching and refitting the power source unit
Procedure
1. Remove the top cover (See page P.1-5-2).
2. Remove the right and left cover (See page
P.1-5-3).
3. Remove the one connector (YC11) form the
connect-L PWB.
4. Remove the two hooks and then remove the
PSU fan motor.
Figure 1-5-38
Connector (YC11)
Connect-L PWB
PSU fan motor
Hook
Hook