Kyocera FS-2000D - Page 97

2F8/2F9/2GA
1-5-25
22. Remove the one connector.
23. Remove the two screws (A) and then
remove the HV plate.
24. Remove the two screws (B) and then
remove the engine R ground plate, engine L
ground plate and shield plate.
25. Check or replace the engine PWB and refit
all the removed parts.
To replace the engine PWB, remove the
EEPROM from the old engine PWB and
mount it to the new engine PWB.
Figure 1-5-33
Connector
Engine PWB
Shield plate
HV plate
Screw (A)
Screw (B)
Screw (B)
Screw (A)
EEPROM
Engine L
grounding plate
Engine R
grounding plate