Kyocera FS-3040MFP - Page 373

11
11-11
Management
Enabling/Disabling Group Authentication
This enables group authentication using the LDAP server. This menu can be used only when [Netwk Authentic.] is
selected as the user authentication method. For details of LDAP server settings, refer to the Operation Guide of the
LDAP server.
Use the procedure below to enable group authentication.
NOTE: Refer to Character Entry Method on Appendix-5 for details on entering characters.
1 Press the System Menu/Counter key on the main unit
operation panel.
2 In the Sys. Menu/Count. menu, press the U or V key to
select [User/Job Account].
If user login administration is disabled, the user
authentication screen appears. Enter your login user
name and password and then press [Login]. For this, you
need to log in with administrator privileges. Refer to
Adding a User on page 11-6 for the default login user
name and password.
3 Press the OK key. The User/Job Account menu appears.
4 Press the U or V key to select [User Login Set.].
5 Press the OK key. The User Login Set. menu appears.
6 Press the U or V key to select [Group Auth.].
Sys. Menu/Count.: a b
*********************
5 User Property
6 Common Settings
[ Exit ]
4 User/Job Account
Login User Name L b
*******************
Login Password:
[ Login ]
User/Job Account: a b
*********************
2 Job Account. Set.
3 Unknown ID Job
[ Exit ]
1 User Login Set.
User Login Set.: a b
*********************
2 Local User List
3 Group Auth.
[ Exit ]
1 User Login
Downloaded From ManualsPrinter.com Manuals