4-71
Operation Panel
2 Press [OK]. The AppleTalk screen appears.
3 Press U or V to select whether AppleTalk is enabled.
4 Press [OK]. The AppleTalk setting is set and the Basic menu
reappears.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1 In the Basic menu, press U or V to select IPSec.
2 Press [OK]. The IPSec screen appears.
3 Press U or V to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1 In the Basic menu, press U or V to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
3 Press U or V to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Basic menu
reappears.