Operation Panel
4-48
3 Press U or V to select the desired character code set.
4 Press [OK]. The character code set is set and the Print Settings
menu reappears.
Print Quality (Setting print quality)
In Print Quality menus, you can set the KIR mode, EcoPrint mode, and other settings.
The options available in Print Quality are as follows:
• KIR (Selecting the KIR mode)...4-48
• EcoPrint (Selecting the EcoPrint mode)...4-48
• Print Resolution (Selecting the Print Resolution)...4-49
• Print Density (Selecting the Print Density)...4-49
1 In the Print Settings menu, press U or V to select Print
Quality.
2 Press [OK]. The Print Quality menu screen appears.
KIR (Selecting the KIR mode)
This printer incorporates the KIR (Kyocera Image Refinement) smoothing function. KIR uses the software to enhance
resolution, resulting in high quality printing at resolution of 600 dpi and 300 dpi. The default is On. KIR has no effect on the
printing speed.
1 In the Print Quality menu, press U or V to select KIR.
2 Press [OK]. The KIR screen appears.
3 Press U or V to select whether the KIR mode is enabled.
4 Press [OK]. The KIR mode is set and the Print Quality menu
screen reappears.
EcoPrint (Selecting the EcoPrint mode)
By enabling EcoPrint mode, you can minimize the amount of toner used during printing. Because images printed in this
mode may be slightly coarser than those printed in standard resolution, you should use EcoPrint for test prints or other
situations where high-quality prints are not required. EcoPrint has no effect on the printing speed.
Use the procedure below to select EcoPrint mode. The default setting is Off.
1 In the Print Quality menu, press U or V to select EcoPrint.
2 Press [OK]. The EcoPrint screen appears.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
