Kyocera FS-4300DN - Page 174

Operation Panel
4-112
The options available in Netwk Auth. Set are as follows:
• Server Type (Server type selection)...4-112
• Host Name (Entering of Host Name)...4-112
• Port (Port number setting)...4-112
• Domain Name (Entering of Domain Name)...4-113
Server Type (Server type selection)
Select the type of server for the authentication server.
1 In the Netwk Auth. Set menu, press U or V to select Server
Type.
2 Press [OK]. The Server Type screen appears.
The available server types are as follows:
NTLM
Kerberos
Ext.
3 Press U or V to select the desired server type.
4 Press [OK]. The server type is set and the Netwk Auth. Set menu
reappears.
Host Name (Entering of Host Name)
Enter the host name for the authentication server.
1 In the Netwk Auth. Set menu, press U or V to select Host Name.
2 Press [OK]. The Host Name screen appears.
3 Enter the host name using the numeric keys.
4 Press [OK]. The host name is registered and the Netwk Auth. Set
menu reappears.
Port (Port number setting)
Set the Port number for the authentication server.
1 In the Netwk Auth. Set menu, press U or V to select Port.
2 Press [OK]. The Port screen appears.
Note Select Ext. to perform ID Card Authentication.
Server Type: a b
1 NTLM
********************-
3 Ext.
2 *Kerberos
Note Up to 64 characters can be entered. For details on
entering characters, refer to Character Entry Method on page
A-2.
To enter the IPv6 address, enclose the address in brackets [ ].
(e.g., [3ae3:9a0:cd05:b1d2:28a:1fc0:a1:10ae]:140)
Host Name: a b
*
ABC
[ Text ]
Note This setting is only displayed when Ext. has been set as the Server Type (Server type selection) on page 4-
112.
Port: a b
/******************-
9093 S