15
Turning Power On
This section describes the procedure for turning on the printer’s power. During start-
up, the language for the message display and status page of this printer can be
selected from English, French, German, Italian, Dutch, Spanish, and Portuguese.
The default message language is English. For how to change the message lan-
guage to another, refer to the Selecting a Message Language section.
1
Switch on the printer’s power. The mes-
sage display should indicate Self
test.
If the indicator does not light,
check that previous steps were
performed properly.
When the printer is first switched on
after installation, there will be a delay
of approximately 15 minutes before
the printer gets ready to print as the
developer unit needs to be filled with
toner. During this period, the message
display shows Please wait (Adding
toner).
2
Wait until the 5($'< indicator is also
lit and the message display indicates
Ready. The printer is ready to print.
Selecting a Message Language
The default message language is English. To change the message language to
another, follow the procedure described below. If required, your dealer can down-
load major languages other than English, French, German, Italian, Dutch, Span-
ish, and Portuguese to your printer. Please contact your dealer.
1
While pressing the (17(5 key, turn the
power switch ON ( O ). Keep pressing the
(17(5 key until the message display
indicates Please wait (approximately
1 minute). The message display should
indicate Self test.
STEP
STEP
7
Power Switch
Ready
--- A4 PLAIN
To Next Page
Loading...
