20
Important note on the interface connectors
Be sure to turn off printer power before connecting or disconnecting an interface cable to the printer. For pro-
tection against static discharge which may be applied to the printer’s internal electronics through the interface
connector(s), keep any interface connector which is not in use capped using the protective cap supplied.
Note: Use shielded interface cable.
Safety information
■ Laser notice
This printer is certified as a Class I laser product conforming to the requirements of IEC 60 825.
DANGER: INVISIBLE LASER RADIATION WHEN OPEN. AVOID DIRECT EXPOSURE TO BEAM.
CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
■ Caution labels
The labels shown are affixed to the printer.
Ozone concentration
The printers generate ozone gas (O
3
) which may concentrate in the place of installation and cause an unpleasant
smell. To minimize concentration of ozone gas to less than 0.1 ppm, we recommend you not to install the printer
in a confined area where ventilation is blocked.
Label inside the printer (Laser radiation warning)
Label inside the rear
Label on the printer’s front side
To Next Page
Loading...
