Kyocera FS-C1020MFP

37
Where to Inquire
Contact your service representative for further information about topics covered in this
manual or to inquire about topics not covered in this manual.
Saving Energy
This machine is equipped with the following Energy Saver modes: Energy Saver mode 1
and Energy Saver mode 2. In Energy Saver mode, the machine's power consumption is
reduced from its normal state.
By default, this machine is set to enter Energy Saver mode 1 if it has been idle for 30
seconds. If another 2 minutes pass, the machine then enters Energy Saver mode 2. The
machine takes about 10 seconds to recover from Energy Saver mode 1, and about 48
seconds to recover from Energy Saver mode 2.
According to your convenience, you can change how long the machine waits before
entering Energy Saver mode 2 by configuring the [Power Saver] setting under [Admin
Settings].
If the machine is in Energy Saver mode 2 for 24 hours continuously, the machine automati-
cally returns to normal state and performs self-maintenance.
For details about [Power Saver], see "Administrator Settings", User Guide in the CD-ROM.
Copyright © 2009
Appendix