4-1
Section 4 BASIC OPERATION
1. Basic copying procedure
1. Warm-up
Turn the main power switch ON ( | ). At the end of warm-up, “Ready to
copy.” will be displayed.
NOTES
• With metric specification copiers you will first need to open the main
power switch cover.
• If you set the originals that you want to copy and press the [Start]
key while the copier is still warming up, copying will begin as soon
as warm-up is finished.
2. Setting the originals
Open the original cover and set the original that you want to copy
face-down on the platen. Be sure to align originals with the upper left
corner of the platen (towards the left-rear portion of the copier).
Inch specifications
Metric specifications
3. Selecting the desired functions
Select from among the copier’s various modes and functions.
• Enlarging/reducing the copy image (Page 4-5.)
• Interrupt copying (Page 4-8.)
• Making 2-sided copies from various types of originals (Page 5-1.)
• Copying each image of open-faced (books, magazines, etc.) or
2-sided originals onto separate sheets (Page 5-4.)
• Fitting the image of either two or four originals onto a single copy
page (Page 5-6.)
• Printing page numbers on the copies (Page 5-9.)
• Overlaying one image over another (Page 5-13.)
• Making booklets from sheet originals (Page 5-15.)
• Making booklets from book originals (Page 5-19.)
• Automatic sorting of copy sets without the Document Finisher
(Page 5-22.)
• Adding a front and/or back cover to your copy sets (Page 5-23.)
• Making more of the same copies after a copy job is finished
(Page 5-26.)
• Copying a large volume of originals in one operation (Page 5-31.)
To Next Page
Loading...
