Preparing to Copy
2-17
1
Adjust the original width guides to fit the originals.
2
Place the originals. Put the side to be copied (or the
first side of two-sided originals) face-up. Slide the
leading edge into the document processor as far as it
will go.
IMPORTANT: Confirm that the original width guides
exactly fits the originals. If there is a gap, readjust the
original width guides. The gap may cause the originals
to jam.
Pull out the ejection guide for originals of 8 1/2 ×14"
(B4) or 11 × 17" (A3).
Ensure that loaded originals do not exceed the level
indicated. Exceeding the maximum level may cause
the originals to jam.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
