Why can't I send documents from my Kyocera All in One Printer?
There are several reasons why you might not be able to send a document: * The modular cord may not be connected correctly. Ensure it is properly connected. * A communication error might be occurring. Remedy the cause of the error and try sending again. * The TX (transmission) restriction might be activated. Cancel the TX restriction.
Why can't my Kyocera KM-3060 All in One Printer receive documents?
There are several reasons why your Kyocera All in One Printer might not be able to receive a document: * The modular cord may not be connected correctly. Connect it correctly. * A communication error may be occurring. Remedy the cause of the error and ask the sender to retry. * The RX (reception) restriction may be activated. Cancel the RX restriction.
What to do if Kyocera KM-3060 All in One Printer FAX box limit exceeded?
The FAX Box capacity is full with document data. Press [OK]. The job is canceled. To resolve this, try the job again after printing or deleting the data in the FAX Box.
What to do if Kyocera KM-3060 cannot perform memory reception?
To resolve the issue, receive after the memory has free space, or create free space in the memory.
What to do if Kyocera KM-3060 All in One Printer cannot perform broadcast transmission?
This issue occurs when there isn't enough free space available in the memory. To resolve this, send after the memory has free space, or create free space in the memory.
What to do if Kyocera KM-3060 All in One Printer job accounting restriction exceeded?
The number of papers used has exceeded the limit preset by Job Accounting, and no further operation is possible. Press [OK]. The job is canceled. Try the job again after resetting the limit for paper use.
What to do if scheduled sending jobs exceeded on Kyocera KM-3060?
The number of jobs has exceeded the limit set for delayed transmission. Press [OK]. The job is canceled. Wait until the delayed transmission is executed, or cancel the delayed transmission and then perform the job again.
Why can't my Kyocera All in One Printer store memory forwarding data in a FAX Box?
There are two possible causes: * The FAX Box may not be specified correctly. Check the memory forwarding setting. * There may not be enough free space available in the memory. Receive after the memory has free space, or create free space in the memory.
Why can't my Kyocera KM-3060 perform sub address transmission?
There are several possible reasons: * The recipient fax machine may not be equipped with a sub address transmission feature. Sub address transmission cannot be performed unless the recipient fax machine has a similar sub address transmission feature. * The entered sub address or sub address password may not be identical to the sub address or sub address password registered in the recipient fax machine. If your entry is correct, check with the recipient. This machine does not use a sub address password for reception. * There may not be free space available in the memory of the recipient fax machine. Check with the recipient.
Why can't my Kyocera All in One Printer perform memory forwarding?
This issue occurs if memory forwarding is not set to [On]. Check the memory forwarding setting.
General| Printing Technology | Laser |
|---|---|
| Print Speed (Black) | 30 ppm |
| Copy Resolution | 600 x 600 dpi |
| Scan Type | Flatbed, ADF |
| Scan Resolution | 600 x 600 dpi |
| Duplex Printing | Yes |
| Memory | 64 MB |
| Max Document Enlargement | 400% |
| Max Document Reduction | 25% |
| Grayscale Depth | 256 levels |
| Processor Clock Speed | 266 MHz |
| Functions | Printer, Scanner |
| Copy Speed (Black) | 30 ppm |
| Fax Capability | Yes |
| Fax Speed | 33.6 kbps |
| Interface | Ethernet, USB |
| Hard Drive | Optional |
To Next Page
