Kyocera KM-C3225 Command Reference

PRESCRIBE Command Reference
4
Text Spacing Commands
These commands control the line spacing, character spacing, underline spacing, and
underline thickness. The SLS and SLPI commands are used to set the line spacing. The
SCS and SCPI commands are used to set the character spacing. These spacing settings
may be changed even in the middle of a page.
The table below lists the minimum, maximum, and default values for the text spacing
command parameters. If values outside of the above ranges are used, the command is
ignored. If a value smaller than one dot is specified for the character spacing, it is
interpreted as 0, which results in proportional spacing.
Using the font mode (FTMD command), the line spacing and character spacing
can be
set automatically when the bitmap fonts are selected. Refer to the sections on the FTMD
and SFA commands for additional details.
Font Commands
The font commands are used to select fonts. Fonts can be selected using substitute
numbers instead of a font’s specific number. It is also possible to change the attributes of
fonts and print them in a unique style. Additionally, there are commands to download
fonts to the printing system from an external source, and to generate fonts.
Minimum value Maximum value Default value
Line spacing 1 dot
0.01 cm
0.004 inch
2,047 dots
17.3 cm
6.8 inch
6 lpi
0.423 cm
0.167 inch
Character spacing 1 dot
0.01 cm
0.004 inch
2,047 dots
17.3 cm
6.8 inch
10 cpi
0.254 cm
0.1 inch
Command Function Page
SCPI Set Characters Per Inch 276
SCS Set Character Spacing 281
SHMI Set HMI 298
SLPI Set Lines Per Inch 309
SLS Set Line Spacing 312
SULP Set UnderLine Parameters 346
Command Function Page
ALTB A [ALlocate TaBle] Assign user-defined character table 14
ALTB C [ALlocate TaBle] Convert character
code 15
AL
TB D [ALlocate TaBle] Delete user-defined character table 16
ALTB E [ALlocate TaBle] End defining combination characters 17
AL
TB G [ALlocate TaBle] Generate user-defined table 18
AL
TB R [ALlocate TaBle] Release user-defined character table 19
ALTB S [ALlocate TaBle] Start to define the combination character 20
ALTB T [ALlocate TaBle] define combined character by Table 21
ALTF change to ALTernate Font 23
ASFN ASsign external characters for FoNt 31

Kyocera KM-C3225 Specifications

General

Brand	Kyocera
Model	KM-C3225
Category	Printer Accessories
Language	English