Kyocera TASKalfa 180 - Page 122

2KL/2KK
1-4-14
(21)
An original jams in
DP is indicated dur-
ing copying (an origi-
nal jam in the original
conveying section 1).
Jam code 71
Defective DP timing switch. Run maintenance item U244 and turn the DP timing switch on and
off manually. Replace the switch if indication of the corresponding
switch is not light.
Check if the original con-
veying motor malfunctions.
Run maintenance item U243 and select the original conveying
motor to be turned on and off. Check the status and remedy if nec-
essary.
(22)
An original jams in
DP is indicated dur-
ing copying (an origi-
nal size error jam).
Jam code 72
Defective DP timing switch. Run maintenance item U244 and turn the DP timing switch on and
off manually. Replace the switch if indication of the corresponding
switch is not light.
Check if the original con-
veying motor malfunctions.
Run maintenance item U243 and select the original conveying
motor to be turned on and off. Check the status and remedy if nec-
essary.
(23)
An original jams in
DP is indicated dur-
ing copying (an origi-
nal jam in the original
conveying section 2).
Jam code 73
Defective DP timing switch. Run maintenance item U244 and turn the DP timing switch on and
off manually. Replace the switch if indication of the corresponding
switch is not light.
Check if the original con-
veying motor malfunctions.
Run maintenance item U243 and select the original conveying
motor to be turned on and off. Check the status and remedy if nec-
essary.
(24)
An original jams in
DP is indicated dur-
ing copying (an origi-
nal jam in the original
conveying section 3).
Jam code 74
Defective DP timing switch. Run maintenance item U244 and turn the DP timing switch on and
off manually. Replace the switch if indication of the corresponding
switch is not light.
Check if the original con-
veying motor malfunctions.
Run maintenance item U243 and select the original conveying
motor to be turned on and off. Check the status and remedy if nec-
essary.
(25)
An original jams in
DP is indicated dur-
ing copying (an origi-
nal jam in the original
switchback section).
Jam code 75
Defective DP timing switch. Run maintenance item U244 and turn the DP timing switch on and
off manually. Replace the switch if indication of the corresponding
switch is not light.
Check if the original switch-
back motor malfunctions.
Run maintenance item U243 and select the original switchback
motor to be turned on and off. Check the status and remedy if nec-
essary.
Problem
Causes/check procedures Corrective measures