2KL/2KK
1-2-14
9. Insert two bands of the key counter wire to
the machine.
Figure 1-2-18
10. Connect the 4-pin connector of the key
counter wire to the YC12 on the main/
engine PWB.
11. Pull the other 4-pin connector out from the
aperture of the right middle cover.
12. Refit the rear cover.
Figure 1-2-19
Bands
Key counter wire
YC12
Aperture
4-pin
connector
4-pin
connector
Key counter wire
Main/engine PWB
To Next Page
Loading...
