Kyocera TASKalfa 180 - Page 51

2KL/2KK
1-3-13
U034
(cont.)
6. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Adjustment: center line adjustment
1. Select group 2 using the image mode selection key.
2. Select the item using the exposure adjustment keys.
3. Press the interrupt key.
4. Press the start key to output a test pattern.
5. Change the setting value using the zoom +/- keys.
For output example 1, decrease the value. For output example 2, increase the value.
Figure 1-3-2
6. Press the start key. The value is set.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
Maintenance
item No.
Description
U034
U066
(P.1-3-20)
U071
(P.1-3-24)
Exposure
indicator
Description Setting
range
Initial
setting
Change in
value per step
Exp. 1 (lit) Paper feed from cassette -7.0 to 10.0 -2.4 0.1 mm
Exp. 2 (lit) Paper feed from MP tray -7.0 to 10.0 0.0 0.1 mm
Exp. 3 (lit) Paper feed from optional first
paper feeder
-7.0 to 10.0 0.0 0.1 mm
Exp. 4 (lit) Paper feed from optional second
paper feeder
-7.0 to 10.0 0.0 0.1 mm
Exp. 5 (lit) Paper feed from optional third
paper feeder
-7.0 to 10.0 0.0 0.1 mm
Exp. 1 (flashing) Duplex mode -7.0 to 10.0 0.0 0.1 mm
Center line of printing (± 1.0 mm)
Correct image Output
example 1
Output
example 2
U034
U067
(P.1-3-21)
U072
(P.1-3-25)