10-48
Troubleshooting > Adjustment/Maintenance
2
Display the screen.
[System Menu/Counter] key > [Adjustment/Maintenance] > "Tone Curve Adjustment"
[Next]
3
Adjust the tone curve.
1 Select [Start]. A pattern is printed.
Check that the number "1" is printed at the bottom of the pattern.
2 As shown in the illustration, place the printed side down on the platen with the edge with
the arrows toward the back.
3 Select [Start]. The pattern is read and adjustment begins.
The second pattern is output.
4 Check that the number "2" is printed at the bottom of the pattern and repeat steps 2 to 3 to
read pattern 2.
5 Select [OK] in the adjustment end confirmation screen.
• Load the paper with the print side facing up.
• After removing new paper from its packaging, fan the paper before loading it in the
cassette.
Loading in Cassette 1
(page 3-4)
• Before loading the paper, be sure that it is not curled or folded. Paper that is curled
or folded may cause paper jams.
• Ensure that the loaded paper does not exceed the level indicator (see illustration
above).
• If paper is loaded without adjusting the paper length guide and paper width guide,
the paper may skew or become jammed.
To Next Page
Loading...
