Default Setting (System Menu)
OPERATION GUIDE 8-31
8
Repeat Copying
Select the Repeat Copy default. The options are as follows. The table below shows the available settings.
NOTE: This setting is not displayed when the optional Data Security Kit is installed or the Repeat Copy job is
set to 0.
Refer to page 4-51 for Repeat Copy.
Use the procedure below to set the default Repeat Copy setting.
1 Press the System Menu key.
2 Press [Common Settings], [ ] and [Next] of
Function Defaults. Press [ ] twice and [Change] of
Repeat Copy.
3 Select the default for [Off] or [On].
4 Press [OK].
Collate/Offset
Set the defaults for Collate/Offset. The table below shows the available settings.
NOTE: Refer to page 3-20 for Collate/Offset.
Use the procedure below to set the default Collate/Offset settings.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function
Defaults. Press [ ] twice and [Change] of Collate/
Offset.
3 Select the defaults for Collate and Offset
respectively.
Item Description
Off No Repeat Copy is performed.
On Repeat Copy is performed.
Item Description
Collate Off Collate not performed.
On Collate performed.
Offset Off Offset not performed.
Each Set
(Each Page)
Offset performed. (If [Off]) is selected of
Collate, it is performed [Each Page].)
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
