Default Setting (System Menu)
OPERATION GUIDE 8-91
8
9 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
RA (Stateless) Settings
Select whether or not to use RA (Stateless). The RA (Stateless) settings are available when selecting [On] for
TCP/IP (IPv6). The default setting is On. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Next] of IPv6.
4 Press [Change] of RA(Stateless).
5 Press [On] or [Off] of RA (Stateless). When
selecting [On], IP Address 1 to 5 (Stateless)
appears.
6 Press [OK].
7 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
DHCP (IPv6) Settings
Select whether or not to use the DHCP (IPv6) server. The DHCP (IPv6) Settings are available when selecting
[On] for TCP/IP (IPv6). The default setting is On. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next]
of TCP/IP Setting.
3 Press [Next] of IPv6.
4 Press [Change] of DHCP.
5 Press [On] or [Off] of DHCP. When selecting [On],
IP Address (Stateful) appears.
6 Press [OK].
7 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
