Kyocera TASKalfa 400ci - Page 357

Default Setting (System Menu)
OPERATION GUIDE 8-93
8
Use the procedure below.
The following procedure is an example for specifying the SMTP (E-mail TX) settings.
1 Press the System Menu key.
2 Press [System] and then [Next] of Network to
display the network settings screen.
3 Display the item you want to set and press
[Change] for that item.
In this example, press [Change] of SMTP (E-mail
TX).
4 Press [On] or [Off].
5 Press [OK].
6 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
NetWare Setup
Select the NetWare network connection. After that, select frame types for NetWare network from Auto,
Ethernet-II, 802.3, 802.2, or SNAP. The default settings are "On, Frame Type: Auto".
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then
[Change] of NetWare.
IPP Select whether or not to
communicate using IPP. When
selecting [On], set the IPP default
Port Number. Use the IPP default
port 631.
Off
Port:631
Y
IPP over SSL Select whether or not to use IPP
over SSL.
SSL must be set to [On] in SSL
Setup on page 8-96.
Off Y
Raw Port Select whether or not to receive
documents using Raw Port.
On Y
* Y: The machine must be restarted after the setting is changed.
N: The machine does not need to be restarted after the setting is changed.
Item Description
Default
Setting
Restarting the
System*
Downloaded From ManualsPrinter.com Manuals