Default Setting (System Menu)
8-98 OPERATION GUIDE
5 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
IPSec Setting
Sets up IPSec. The default setting is Off. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network Security, and
then [Change] of IPSec.
NOTE: If user login administration is disabled, the
user authentication screen appears. Enter your login
user name and password and then press [Login]. For
this, you need to login with administrator privileges.
Refer to Adding a User on page 11-4 for the default
login user name and password.
3 Press [On].
4 Press [OK].
5 After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
LAN Interface Setup
Specify the settings for the LAN interface to be used. The default setting is Auto. Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then
[Change] of LAN Interface.
3 Select [Auto], [10BASE-T Half], [10BASE-T Full],
[100BASE-TX Half] or [100BASE-TX Full] as the
LAN interface.
To Next Page
Loading...
