Default Setting (System Menu)
9-96
RA (Stateless) Settings
Select whether or not to use RA (Stateless). The RA (Stateless) settings are available when selecting [On] for
TCP/IP (IPv6). The default setting is On.
IMPORTANT: After changing the setting, restart the network from the system menu, or turn the machine OFF
and then ON. For detailed information on restarting the network, refer to Restart Network on page 9-104.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3 Press [Next] of IPv6.
4 Press [Change] of RA(Stateless).
5 Press [On] or [Off] of RA (Stateless). When selecting [On], IP Address 1 to 5 (Stateless) appears.
6 Press [OK].
DHCP (IPv6) Settings
Select whether or not to use the DHCP (IPv6) server. The DHCP (IPv6) Settings are available when selecting
[On] for TCP/IP (IPv6). The default setting is On.
IMPORTANT: After changing the setting, restart the network from the system menu, or turn the machine OFF
and then ON. For detailed information on restarting the network, refer to Restart Network on page 9-104.
Use the procedure below.
1 Press the System Menu key.
2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3 Press [Next] of IPv6.
4 Press [Change] of DHCP.
5 Press [On] or [Off] of DHCP. When selecting [On], IP Address (Stateful) appears.
6 Press [OK].
To Next Page
Loading...
