Default Setting (System Menu)
9-28
Repeat Copy
Select the Repeat Copy default. The options are as follows. The table below shows the available settings.
NOTE: This setting is not displayed when the optional Data Security Kit is installed or the Repeat Copy job is
set to 0.
Refer to page 4-43 for Repeat Copy.
Use the procedure below to set the default Repeat Copy setting.
1 Press the System Menu key.
2 Press [Common Settings], [ ] and [Next] of Function Defaults. Press [ ] three times and [Change] of
Repeat Copy.
3 Select the default for [Off] or [On].
4 Press [OK].
DP Read Action
Set the operation when a document is scanned from the document processor. The table below shows the
available settings.
NOTE: Cannot be used when set to [On] in Document Guard on page 9-103.
Use the procedure below to set a DP Read Action.
1 Press the System Menu key.
2 Press [Common Settings], [ ] and [Next] of Function Defaults. Press [ ] three times and [Change] of DP
Read Action.
3 Select [Speed Priority] or [Quality Priority].
4 Press [OK].
Item Description
Off No Repeat Copy is performed.
On Repeat Copy is performed.
Item Description
Speed Priority Priority given to scanning speed.
Quality Priority Priority given to image quality.
To Next Page
Loading...
