COMPONENT MAINTENANCE MANUAL
AVIATION RECORDERS
Model FA5000
Initial Issue Page 709
Sep. 30/11
Assembly
23–70–40
Use or disclosure of information on this sheet is subject to
the restrictions on the cover page of this document.
NOTE: Apply Loctite to all screw installations for the following proced-
ures:
(3) Place six washers (1−130) over screw hole of CSMU. Lift−up CSMU (1−120) to
Mounting Chassis (1−100) and align with mounting screw holes.
(4) Install the six screws (1−125) used to secure the CSMU (1−120) to the mount-
ing chassis (1−100). Tighten screws to a torque value of 31 in./lbs
(5) Install Seal Pad (1−140) and the CSMU (1−120) cable connector to the MP
PWA (1−50) and secure with installing two screws (1−135). Tighten screws to a
torque value of 5−10 in./lbs
(6) Install CSMU cable cover plate (1-110) and secure with installing two screws
(1−115). Tighten screws to a torque value of 5−6 in./lbs
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
