Two-Tone Atomic Digital Clock
ALARM
SET ALARM
1. Hold the ALARM button 3 seconds to enter settings mode.
2. Press the + or - button to adjust the flashing values.
3. Hold the + or - buttons to adjust quickly.
4. Press the ALARM button to confirm adjustments and move to the next item.
5. Press the SNOOZE button at any time to exit.
ACTIVATE/DEACTIVATE ALARM
• The alarm is active when set.
• From normal time display, press and release the ALARM button to deactivate or activate the alarm.
The alarm time will show for 2 seconds.
• Alarm icon will show then active.
Alarm Hours Alarm Minutes Alarm ON Alarm OFF
SNOOZE
• When alarm sounds, press the SNOOZE button to silence alarm for 10 minutes.
• The alarm icon
will flash.
• Press any button except SNOOZE to silence the alarm for 24 hours.
Note: When the alarm sounds, it continues for 2 minute and then shuts o completely.
CHANGE BATTERIES
Sensor:
1. When Battery Indicator shows next to the Outdoor Temperature, replace batteries in your Outdoor
Sensor.
2. Then hold the PLUS (+) button for 3 seconds and your clock will search for your sensor.
Clock:
1. When Battery Indicator shows next to the Indoor Temperature, replace batteries in your Clock.
2. Then hold the PLUS (+) button for 3 seconds and your clock will search for your sensor.
Factory Restart:
1. Bring sensor within 5 feet of your clock. Remove batteries from clock and sensor for 15 minutes.
2. With batteries out, press any button on the clock 20 times.
3. After 15 minutes insert fresh batteries into your sensor and into your clock.
Page | 6
To Next Page
Loading...
