17 | Page
• Be sure you have good batteries. Manually search for your sensor by holding the TEMP
button.
• Bring your sensor within 10 feet of your station and make sure it is connected to the station.
• After 15 minutes move the sensor into the next room with a wall between the sensor and the
station for 1 hour.
• If there is no loss of signal in that hour, move the sensor just outside.
• Continue moving the sensor back to its original location.
• If you lose connection, look for sources of interference.
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
• On your sensor, open the battery cover and press the F/C button. This will change the
temperature display on the sensor only.
• On your station enter the program menu to select Fahrenheit or Celsius temperature display
on the station.
TEMPERATURE INTERMITTANT: WHY DO MY READINGS COME AND GO?
• RF (radio frequency) communication may come and go occasionally. This can be normal in
some environments (e.g. moister climates).
• If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient
– these stations can reconnect on, after many hours out.
• RF (radio frequency) communication is not always 100% on. Certain temporary conditions
can cause it to go out for a time (e.g. 100% humidity).
• Check that your sensor is receiving full sun on the solar panel.
• If your TH sensor loses connection to the station for any reason, the station will show dashes
after 30 minutes.
• The station will search for 5 minutes every hour to reconnect with TH sensor.
• Bring your sensor within 10 feet of your station and make sure it is connected to the station.
• After 15 minutes move the TH sensor into the next room with a wall between the sensor and
the station for 1 hour.
• If there is no loss of signal in that hour, move the TH sensor just outside.
• Continue moving the TH sensor back to its original location.
• If you lose connection, look for sources of interference.
To Next Page
Loading...
