21
The last LCD section can show the outdoor temperature, the reception indicator and
the minimum or maximum reading. A number beside the temperature will also be
shown if more than one remote temperature sensor has been used.
TOGGLING AND RESETTING THE OUTDOOR RECORDINGS:
1. To toggle between the outdoor current, maximum and minimum temperature
data and the times they were recorded press and release the “MAX/MIN R”
button:
• Once to show the maximum outdoor temperature data with the recorded
time and date.
• Twice to show the minimum outdoor temperature data with the recorded
time and date.
• Three times to return to the current displayed values.
2. To toggle between transmitters, press and release the “CHANNEL” button:
• Once to show transmitter 2
• Twice to show transmitter 3
• Three times to return to transmitter 1
Note: The transmitter number will only be displayed if there is more than one
transmitter being used.
3. To reset the maximum and minimum outdoor temperature, and the time at which
they were recorded, press and hold the “MAX/MIN R” button for 4 seconds.
This will reset all minimum and maximum data recorded to the displayed values
for the selected remote temperature sensor.
ADDING OUTDOOR REMOTE TEMPERATURE SENSORS (OPTIONAL)
The WS-9016U is able to receive signals from 3 different remote temperature
sensors. The remote temperature sensor model(s) that you choose will come with
their own set of instructions. Follow these instructions for a complete guide to
setting up. Following are some brief instructions for the basic set-up of remote
temperature sensor units with the WS-9016U. These extra remote temperature
sensors can be purchased through the same dealer as this unit, or by contacting La
Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will
monitor temperature and display the temperature on its LCD, and the TX3UP will
monitor the temperature via a probe for measuring soil or water temperatures..
To Next Page
Loading...
Need help?
General
