24
THE INDOOR TEMPERATURE STATION
The indoor temperature station can be mounted in two ways:
• with the table stand
• on the wall with the use of a wall hanging screw (not included)
A. USING THE TABLE STAND
The indoor temperature station comes with the table stand
already mounted. If you wish to use the table-stand all that is
required is to place the indoor temperature station in an
appropriate location.
B. WALL MOUNTING
1. Remove the table stand. To do this, pull down on the
stand from the rear and rotate forward.
2. Fix a screw (not included) into the desired wall leaving
approximately 3/16 of an inch (5mm) extended from the
wall.
3. Place the indoor temperature station onto the screw using
the hanging hole on the backside.
4. Gently pull the station down to lock the screw into place.
To Next Page
Loading...
Need help?
General
