24
By default the alarm delays are as shown in the images above.
Alarm Thresholds
The Alarm Thresholds setting allows the customer to determine the current or voltage value at which an alarm
triggers. The threshold can be changed for Low Current Alarm, Low Current Alarm Reset, Overload Alarm, Low
Voltage Alarm, Low Voltage Alarm Reset, End of Discharge Alarm, High Voltage Alarm, and High Voltage
Shutdown Alarm.
Alarm threshold defaults are based on the charger output. The alarm threshold values shown above are not
representative of the default values for any specific TPSD charger.
Alarm Operation
The Alarm Operation setting defines if the alarms relays latch. If any alarm contacts are set to latch, the alarm
will not clear until the ALARM RESET button is pressed, even if the alarm condition returns to normal.
If Latch All Alarms is set to NO, the settings menu advances to allow the customer to set each alarm operation
individually. By default no alarms are set as latching,
except High Voltage Shutdown (HVSD)
, these alarms will
clear after the condition returns to normal.
NOTE: The HVSD alarm latches by default and cannot be changed.
3.4.1.4. Temperature Compensation Settings
The temperature compensation setting allows the customer to enable/disable temperature compensation. By
default temperature compensation is set to OFF.
< HV Alarm Delay
5 Seconds
< HVSD Alarm Dly
20 Seconds
< Auto EQ on L
delay 30 Secs
< Alarm >
Thresholds
< Low DC Current
Alarm 0.2 A
< Low DC Current
Reset 0.4 A
< Over Current
Alarm 18.0 A
< Over Current
Reset 16.5 A
< Low Voltage
Alarm 118.8 V
< Low Voltage
Reset 8 Percent
< End of
Discharge 100.8V
< End Discharge
Reset 10 Percent
< High Voltage
Alarm 147.0 V
< High Voltage
Reset 135.0 V
< HV Shutdown
Alarm 150.0 V
< Alarm >
Operation
< Latch All
Alarms? NO
To Next Page
Loading...
