14 | MSD Legend Series Operation & Maintenance Manual
Trapped hydraulic pressure may be present after the base
removing hydraulic hoses or lines. Injury or death could result.
7. Disconnect the hydraulic ttings. Plug the ttings,hoses and lines to prevent contamination of the hydraulic oil.
8. Ensure the shear is properly blocked-up and can receive the total weight of the shear.
9. Remove the boom pin from the shear.
STORING THE SHEAR
1. Grease the shear, as described in “Shear Lubrication” on page 23.
2. Fully retract the shear cylinder.
3. Block the shear o the ground using wood blocking. Ensure the shear is stable and will not move.
4. Plug all open hydraulic ports.
Note: While in storage, grease the turntable bearing every 6 months. See “Shear Lubrication” on page 23.
To Next Page
Loading...